Kiev, Ukraine 17-07-2017
The success of software projects highly depends on the level that their outcomes (i.e., the developed software products/services) satisfy the needs of all stakeholders and software requirements encompass these needs. In this paper, a state of the art survey is presented in the area of Requirements Engineering (RE). The paper presents the problems solved through the RE processes, summarizes the current research and industry status in the field and presents a classification scheme of various RE methodologies. The paper concludes by discussing the current research/industry trends in the field of RE.
Keywords- Software Projects, Requirements Engineering, State of the Art.
In this investigation, Al-1.94Mn-0.5Cu (wt.%) alloy was directionally solidified at different solidification rates varying from 8.3 to 978 m/s at a constant temperature gradient (7.1 K/mm). The microstructure was analyzed by optical microscopy and scanning electronic microscopy. Especially, cell-dendritic transition was detected for low solidification rate (8.3 m/s). Then with increasing solidification rate, the microstructure is completely converted to a dendritic form. The microhardness increased from 470 to 520 MPa and the tensile strength increased from 109 to 145 MPa with increasing the solidification rate from 8.3 to 978 m/s. Exponent values of the V for the microhardness and tensile strength were calculated as 0.04 and 0.06, respectively. Fracture surface images of the studied alloys were analyzed depending on solidification rate. These fracture surfaces exhibited a lot of small dimples, a characteristic of ductile fracture. Many micro-cracks start from these voids and dimples. The mode of fracture significantly changed from ductile to less ductile with the increase of the solidification rate.
Index Terms- Directionally solidification, microstructure, microhardness, tensile strength, fracture.
The directional solidification process of ternary Al-1.94Mn-0.5 Si eutectic alloy within a wide growth velocity range from 8.3 to 978 μm/s was accomplished at a constant temperature gradient of 4.9 K/mm. The microstructures of produced samples were characterized by using optical microscopy (OM), scanning electron microscopy (SEM) and Energy dispersive x-ray analysis (EDX). Dendritic microstructures were observed in the directionally solidified samples. The dendritic spacing tends to decrease with increasing growth velocity. As growth velocity increases, the dendritic spacing decreased from 160 to 68 m. Microhardness and tensile strength at room temperature were examined by tensile tests. It was found that the microhardness and ultimate tensile strength increased with increasing growth velocity, which ranged from 8.3 to 978 μm/s. Exponent values of the V for the microhardness and tensile strength were calculated as 0.05 and 0.09, respectively. Fracture surface images of the studied alloys were analyzed depending on growth velocity. The fracture mode transforms from ductile form to less ductile form with the increase of the growth velocity.
Index Terms— Fracture, microhardness, microstructure, tensile strength, Ternary eutectic alloy,