Rawalpindi, Pakistan 29-06-2017
Lead-free ternary (1–x)(Bi1.05FeO3)–0.02LiNbO3–xBaTiO3 (BFLNBT, with x = 0.34–0.40) system were synthesized by conventional solid-state reaction method. The influence of BT-content on the crystal symmetry, dielectric properties, ferroelectric properties and field induced response of BFLNBT was investigated. The crystal symmetry were studied by X-ray diffractometer, which showed that all BFLNBT compositions possessed single phase perovskite structure with pseudocubic symmetry at room temperature. The ferroelectric behavior of BFLNBT system were successfully measured with fully and slim saturated polarization vs electric field (P–E) loops, under an applied field of 70 kV/cm. The maximum polarization (Pmax) and remnant polarization (Pr) of BFLN–0.34BT were 32 μC/cm2 and 19 μC/cm2, respectively. At applied electric field of 7 kV/mm, the optimum (x = 0.34) ceramic composition show large normalized strain (d*33= Smax/Emax =) of 322 pm/V.
Keywords- Lead-Free, Dielectric, Ferroelectric, Field Induced Strain Properties
The purpose of this research is to prepare cellulose acetate (CA) based membranes for hemodialysis. It is intended to blend hydroxyapatite (HA) with CA in the presence of polyethylene glycol (PEG). The blended membranes were tested for the effectiveness in dialysis application. Later contact angle and pure water flux of blended membranes were determined to investigate the alterations in CA/PEG matrix after HA addition. Surface morphology of CA/PEG/HA blended membranes was studied using SEM, AFM, FTIR. The results revealed effective and homogeneous blending of CA, PEG and HA. The blended membranes were also tested for Bovine serum albumin (BSA) rejection and urea clearance in order to view their application in dialysis process. The increase of HA weight % in doped solution improved BSA rejection and Urea clearance up to 96.8% and 55.2 % respectively. Prominently, addition of HA to CA/PEG matrix imparted better compaction, protein absorption and porosity which lead to membranes with enhanced BSA rejection, Urea clearance and hydrophilicity.
Keywords- CA/PEG/HA blended membranes, Hemodialysis, BSA rejection, Urea Clearance.
The primary aim of this research was to investigate the flexural behavior of composite reinforced concrete (RC) beams having an Engineered Cementitious Composite (ECC) layer at the bottom face. ECC is a mortar based composite reinforced material, which has improved properties of high ductility, tensile and flexural strength. For this purpose, four full scale composite RC-ECC beams and two RC control beams were casted and tested under third point bending in the straining frame. Two different ECC layers having thickness of 75 mm and 100 mm were used to study the effect of layer thickness. After careful test results, the average cracking load for the composite beams was increased by 32% and 70% and the average yield load increased by 11% and 19% for 75 and 100 mm layer of ECC respectively, as compared to RC Control beams. Similarly the average ultimate load for composite beams was found slightly decrease but the individual value was observed more. Furthermore the mid span deflection of the beams was observed to increase at crack load & yield load.
Keywords: ECC, PVA fibers, Fly ash, Deflection, Flexural Behavior