Langkawi, Malaysia 18-08-2018
Air pollution has been a concern to mankind since peak of Industrial Revolution. Over the years, the increasing concern of air pollution has led to establishment of ambient air quality standards. One of the six major pollutants listed in most ambient air quality standards is nitrogen dioxide (NO2). NO2 is typically emitted due to incomplete combustion of diesel, from vehicles and high thermal unit operations like cement-kilns and power plants. Measurement of pollutants, such as NO2 in ambient air can be conducted in two ways; active sampling or passive sampling. Conventionally, active sampling is used to measure the presence of nitrogen oxide in ambient air. However, in recent years, there have been various developments in passive sampling methods. Passive sampling does not require power source for operation whereby the air pollutants are trapped onto sorbent material by diffusion mechanism. This project was carried out to evaluate NO2 concentration by using passive samplers in industrial area in Sungai Buloh. The measurement of NO2 from passive sampling is then compared with the data of NO2 concentration from nearest Continuous Air Quality Monitoring Station (CAQMS) in Petaling Jaya to measure accuracy of the passive sampler. Average concentration of NO2 measured by using passive samplers in Sungai Buloh was 0.034 ppm, while CAQMS Petaling Jaya which uses active sampling showed an average NO2 concentration of 0.042 ppm. The data collected using passive samplers in Sungai Buloh is lower by 19% compared to data at CAQMS Petaling Jaya. This is due to distance of approximately 10.5 kilometers between the two points. In Sungai Buloh, major sources of NO2 pollution is due to transportation and manufacturing activities. From this project, it can be concludedthat passive sampling can be considered as a alternative to measure NO2 in ambient air which can be implemented in monitoring stations in Malaysia.
Keywords - Air Pollution, Nitrogen Dioxide, Passive Sampling, Air Monitoring
The understanding of religion plays the main role in shaping a good society. As an Islamic country, Malaysia has entrusted the responsibility of every state governments to implement Islamic rules in the country. Thus, all the rules concerning religion were the responsibility of the state government in each country. As a result, the Kelantan state government is taking the opportunity given by the government to implement the Islamic administration in their country by introducing a new policy that is "developing with Islam". Thus, this study will help to identify the appropriate indicators and subindicators of the socio taqwa index in order to measure the relationship between religion and the country in order to know in what extent this policy has been implemented in the Kelantan States Government. Thus, the appropriate indicators and subindicators were chosen by the panel of experts from various field. In this study also, we apply the Fuzzy Delphi method in order to know the exact value of the indicators and subindicators chosen by the experts panel. Fuzzy Delphi Method was conducted in two stages that is FDM 1 was identifying the main indicators and the FDM 2 to determine the sub-indicators.
Keywords - Implementation, Index, Socio taqwa, Fuzzy Delphi Method
The development and application of appropriate instructional materials is necessary. The gap in the availability and utilization of appropriate instructional materials adhering to Bruner’s Constructivism, Dale’s Cone of Experience, and Experiential Learning Theory makes a misalignment in the K to 12 Curriculum, thus fails in achieving learning competencies and assessment procedures. This research is a qualitative interpretative single-case study focused on the experiences of a math teacher on a low performing school as identified by the Department of Education, Division of Tacloban City, Philippines in the production and utilization of instructional materials. Research data were gathered through an intensive interview and analyzed by having three cycles of coding. Findings of the study revealed that there are plenty of factors affecting teacher, production and utilization of instructional materials, and students’ academic performance. It is an eye-opener on the challenges and difficulties teachers face in everyday teaching.
Keywords- Instructional Materials, Interpretative Single-Case Study, K to 12 Curriculum, Mathematics.
With this attempt as a backdrop that enhancing students critical thinking (CT) in instructional practices is of vital importance in ESL/EFL classrooms, the current study was carried out to investigate the effect of Socratic questioning (SQ) on students CT skills with reference to the five domains of CT 1). Inference, 2). Recognition of Assumptions, 3). Deduction, 4). Interpretation, and 5). Evaluation of Arguments, in grade 12 in Omani female schools. The present study made an attempt to look for differences among students in using CT skills in reading classes. A quasi-experimental design was used in this study. Therefore, a total of 60 EFL female students distributed in two groups. Data analysis showed statistically significant differences between mean scores of those who are taught through SQ and those obtained by students who are taught CT skills in a normal setting. The students in the experimental group managed to implement better CT skills than those who were taught through traditional methods. Also, results showed that CT domains were significantly affected by SQ skills. In view of the discussion of findings pedagogical implications are explored and recommendations made.
Keywords - Evaluative Questions, Probing and Illustrating Questions, Recognition of Assumptions Questions.
A stock market prediction is a critical issue for investors and market expert alike. In this paper, we acquire experts’ opinions and try to find the best possible scenarios for investors. As it is known that experts’ opinions and beliefs are subject to prediction and hence inexact reasoning. Two approaches are used to determine a consensus among experts. The first approach is via the use of the theory of belief (Dempester’s Rule of Combination), and the second approach is via the use of the Fuzzy Fusion Formula that is able to integrate (fuse) expert’s opinions. The outcome of belief combination is favorable guidelines for investors and decision-makers dealing with a fluctuating stock market. The experimental results of both approaches are evaluated and compared.
The effectiveness of the Emergency Medical Trauma Services (EMTS) is dependent on a diverse range of decision making, planning and operational phases, such as ambulance locations and dispatching protocols. An important indicator of the quality of care and service delivery in the Emergency and Trauma Department (ETD) is the satisfaction of the patients. The objective of this study was to evaluate the patients’ satisfaction factors towards ambulance and ETD services. This study was carried out with the aid of questionnaires, followed by descriptive and analytical statistics using Analytic Hierarchy Process (AHP). Respondents of 150 patients were randomly selected. Based on the overall priority scores of satisfaction factors of patients in the ambulance services, for the domain priority, it was found that the efficiency of services was ranked the highest at 34.3% and lowest ranking for vehicles at 5.24%. Based on the overall priority scores of satisfaction factors of patients in the emergency department, for the domain priority, it was found that the staff performance was ranked highest at the 39.41% and lowest ranking for efficiency of services at 13.28%. From the analysis, it was found that the most important satisfaction factor in EMTS is the speed of admittance of patients to the hospital, and the length of waiting period before admittance into the examination room. From the calculations of the priorities of the EMTS, the satisfaction factors could be used to develop a lean management approach and thus, further research can be conducted on AHP analysis and operational decision making in order to improve the quality of the EMTS system.
Index Terms - Emergency Medical Trauma Services (EMTS), satisfaction factors, lean management approach, operational decision making.
This paper is an exploration into the possibility of outlining a verification procedure and construction of an Index of Acceptability of Islamic contents made available via the Internet especially YouTube videos. Inference are made from guidelines on source reliability presented by university libraries and the Islamic traditional science of classification of the Prophetic sayings and traditions (Hadith). A rudimentary formula (IA = QlS + QlR + QNR + QlT) is proposed to start this exploration. It is projected that robust and usable material acceptability indexing procedure can be evolved through time. Given the overwhelming quantity of materials easily downloadable from the Internet, the question of quality must also be addressed. The perceived possibility of negatively interpreted religious sources towards inciting conflict must be mitigated by efficient methods of sorting and gatekeeping inflamatory materials. Of all the variables for inclusion into the indexing formula, the source’s authority must top the list.
Index Terms - reliability index, source credibility, verification
Advanced Encryption Standard (AES) is a block cipher system which widely used in cryptographic application. Substitution box (S-box), nonlinear substitution operation, is the main factor of the AESstrength.The reason of construction S-boxes for symmetric key cryptosystems is to yield good properties such as high nonlinearity andlow autocorrelation. The main objective of this research is suggesting mathematical approach to generate random S-boxessuitable for symmetric key cryptosystems. The fact that S-boxes are randomly key-dependent and unknown is the main strength of the new approach, since both linear and differential cryptanalysis requires known S-boxes. In this paper, briefly analyze of the AES algorithm, substation-boxes, linear and differential cryptanalysis are introduced. Moreover, a randomly key-dependent S-box, inverse S-box generation algorithm andthe significant properties of proposed S-boxes are described. Preliminary results show that our proposed algorithm has good cryptographic strength, fast, low complexity, and resistant against linear and differential cryptanalysis.
Keywords - Cryptography, Symmetric key,AES and RijndaelS-box.Cryptanalysis.
This study is aimed at investigating the effect of engine speed on the Dual cycle performance with considerations of heat transfer and friction irreversible losses. By using finite time thermodynamics theory, the characteristic curves of the power output versus compression ratio and the power output versus thermal efficiency are obtained. The results show that the maximum power output and the power output at maximum thermal efficiency increase with increasing engine speed and then decrease. The results also shows that if compression ratio is less than certain value, the power output increases with increasing engine speed, while if compression ratio exceeds certain value, the power output first increases and then starts to decrease with increasing engine speed. With further increase in compression ratio, the increase of engine speed results in decreasing the power output. This paper provides an additional criterion for use in the evaluation of the performance and the suitability of a dual engine.
Index terms - Finite time thermodynamics; Performance analysis; Dual cycle
In this paper, a performance analysis and optimization based on the ecological criterion has been performed for an air-standard endoreversible internal combustion engine Otto cycle coupled to constant temperature heat reservoirs. The cycle consists of two constant thermal-capacity heating branches, a constant thermal-capacity cooling branch and two adiabatic branches. The analytical formulae for thermal efficiency and ecological function of the Otto endoreversible thermodynamic cycle with heat resistance loss are derived. The results include the performance characteristics of endoreversible steady flow Otto cycle. The results can provide some theoretical guidance for the design of practical Otto engines.
Index terms - Finite-time thermodynamics, Efficiency; Entropy-generation rate, Ecological function.
Protection of freshness and extending shelf life of fish, meat and other derived products is one of the greatest challenges of industries [1, 2]. One of the most important needs in the food industry is determining the freshness of fish meat because this factor is the most important criterion for manufacturing high quality foodstuff. It is well known that after the death of a fish, ATP is degraded into xanthine, which the levels of xanthine in fish product increases with the storage of fish meat. Thus, determination of xanthine level in meat provides can be considered as a powerful tool in the food industries for evaluating the freshness of fish meat [3]
In the present work, sensitive and selective detection of xanthine molecule in food industries is of tremendous important for evaluating the meat freshness. A new and simple-to-preparenanobiocomposite forimmobilization of xanthine oxidase (XO) is describedbyincorporating multi-walled carbon nanotube (MWCNT) and poly(aspartic acid) composite film electrodeposited on glassy carbon electrode (GCE). The optimization of bio-analytical experimental condition such as percentage of MWCNT, immobilizing time of the enzyme, the response time of electrode and the working pH was performed in detail. The fabrication process of the enzyme electrode was pursued by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and scanning electron microscopy (SEM).The developed biosensor was employed for the determination of xanthine in fish meat based on differential pulse voltammetry (DPV) method.The DPV study of XD/poly (Aspartic acid)/ MWCNT/GCE exhibits wide linear range (5.0×10-9- 50×10-6 mol.L-1), with a detection limit of 1.6×10-9 mol.L-1 and surprisingly high selectivity. Finally,the developed biosensor was successfully applied for xanthine determination in fish meat at different storage time.
Keyword: Electrochemical biosensor; Multi walled carbon nanotube;Electropolymerization; Fish meat;Xanthine oxidase; Xanthine; Poly(aspartic acid).