Indonesia, 04-12-2014
ISBN 978-93-84209-70-4
Gasification system is one example of the utilization of biomass for energy. It converts solid fuel into gasification
combustible gas like CO, H2, and CH4 because of the reaction occurring in the gasification reactor to be used later as an
energy source. This research will test the updraft gasification system by modifying it into a system with two outputs, namely
in the area of the gasifier as a conventional system and the area under the gasifier in an effort to reduce the tar content in gas
can burn. This study uses a blower with a flow rate of 108 lpm and the results of testing will be compared with the
conventional system in order to get the characteristics of the test. The results of these tests indicate that the gas could be
burned out of both pieces of pipe flow with LHV value of each is 4.470 MJ/m3
for the top and bottom area of 4.082 MJ/m3
for which the fuel gas composition coming out of the upper area and below the percentage value that is approximately the
same for CO 22.695% to 20.805%, H2 gas of 9.835% versus 9.05%, and CH4 gas at 2.66% versus 2.38%. While the value
obtained from the conventional system is 4.473 MJ/m3
with gas composition of CO, H2, and CH4 at 21.92%, 10.51%, and
2.74% respectively. Cold gas efficiency for systems with two output areas has a higher value than the conventional system is
53.087% to 46.519%.
Keywords- Gasification, Rubber Wood, Double Gas Outlet and Syngas
A cross sectional study of physiological and psychological effects on heat acclimatization in hot environment
was conducted among construction workers in Pahang, Malaysia. The goals of this study are to assess the physiological
(blood pressure, heart rate and oral temperature) and psychological (fatigue feeling) effects of workers in hot environment.
A correlation between fatigue feeling and physiological effects is determined. An increment of physiological parameters
toward exposure of heat environment proves that the workers are affected by heat acclimatization. The finding of this
study reveals that there are significant differences between before and after session of oral temperature (p = 0.0001), heart
rate (p = 0.0001), systolic blood pressure (p =0.0001), diastolic blood pressure (p =0.0001) and sweating rate (p =0.004)
among the workers who are working in hot environment. The relationship between fatigue and physiological effects reveals
with spearman test that the correlation is weak (p < 0.05). The results show that the physiological changes happen during
workers conducted their jobs under hot environment. Only physiological of workers were shifted to achieve the heat
acclimatization in extreme hot environment.
Keywords- Hot Environment, Heat Acclimatization, Physiological, Psychological, Fatigue
We present a semi-proving method for verifying necessary conditions for program correctness. Previously an
integrated program method was introduced for Testing, Debugging and Proving a program results for check that program
may have any modification in execution. Previous method can be developed based on metamorphic relations, Symbolic
analysis of and path constraint simplifications. Metamorphic method can be applied to correctness of a program to tested
inputs related to untested inputs. These Methods can be applied for generating test cases with original tested inputs. Prior
approaches use four metamorphic relations to initiate metamorphic testing for the verification of software output without a
complete testing oracle. So the main disadvantage of this aspect is shortage of test case generation. To increase the frequency
of number of test cases we propose a new approach. Our proposed new approach contains all the metamorphic relations
available in testing process for generating the test cases.
Index Terms: Symbolic analysis, metamorphic relations, testing debugging global symbolic evaluation, program proving.
Electrocardiogram is the recording of the electrical potential of heart versus time. The analysis of ECG signal has
great importance in the detection of cardiac abnormalities. In this paper we have dealt about the removal of noises in ECG
signals and arrhythmia classification of the signal.The inputs for our analysis is taken from MIT-BIH database
(Massachusetts Institute of Technology Beth Israel Hospital database). The denoising is done through wavelet transform and
thresholding. Confirmatory tools such as Poincare plot and Detrended Fluctuation Analysis (DFA) are used to find out the
healthiness of the signal. Then Support Vector Machine (SVM) is used to find out what type of arrhythmia is present in the
signal.
Keywords- Classification, DFAElectrocardiogram, MIT-BIH database, Poincare, SVM , Wavelets.
Identification of blood group plays a vital role in the medical field for any treatment. Miss-transfusion of blood will
lead to many complications. This paper provides an easy and fast means of identification of blood groups. The difference in the
amount absorption by each blood group is exploited so as to categorize the blood groups. The light from the pulsating IR LED
is passed through the blood sample via an Optical Fiber Cable (OFC) and the transmitted light is then detected, conditioned
and is converted into voltage signal. The variations in the intensity of the received signal due to the absorption of blood for
different blood groups are translated into corresponding voltage changes, to classify the blood groups.
Index Terms- Blood groups, HFBR1415TZ IR LED, Optical fibers, Optical properties, PIN photodiode, Receiver,
Transmitter.